Fire Protection

Below find detailed information concerning each of the following topics:

 

Suggested Use

Modular Offices™ recommends the use of fire protection in any of the following circumstances...

  • Hazardous "combustible" areas
  • Chemical plants
  • Paint booths
  • Load bearing walls.
  • Exit corridors
  • Tenant separations
  • Nuclear plants
  • High occupancy rooms

---------- TOP ----------

 

Endurance / resistance

Fire Endurance and Resistance test ASTM E119.

Similar tests: UL 263 / UBC 43-1 / NFPA 251 / ANSI A2.1

The standard achieved is used to determine the time a material will contain a fire and retain its structural integrity. The test exposes a sample (10'x10') to specific fire temperatures according to a time temperature scale and for a predetermined time, then subjects the sample to a standard fire hose stream. If the sample stays intact then the material has passed the test for that predetermined time frame. If it fails then you must start again and use a shorter time frame. Unless several tests are run at a very high cost each, a company may never know the full capabilities of their product.

---------- TOP ----------

 

1 Hour Systems

Modular Offices™ is the only manufacturer of ASTM E-119 Certified Fire-Rated Products

1 HOUR SYSTEM:

  • 5/8 GYPSUM / STUD-INSULATED CORE / 5/8 GYPSUM PANEL

This System utilizes Modular OfficesPATENT PENDING Fire Rated post (panel connection) system.
Our Certification was completed using this post system. This represents the industry's ONLY PANELIZED SYSTEM capable of achieving a ONE Hour Fire Rating.

---------- TOP ----------

 

2 Hour Systems

Modular Offices™ is the only manufacturer of ASTM E-119 Certified Fire-Rated Products

2 HOUR SYSTEM:

  • 6" STEEL FRAMED PANEL WITH STEEL MECHANICALLY FASTENED ON 5/8 GYPSUM , WITH A INSULATED CORE MATERIAL.

This represents the industries ONLY PANELIZED SYSTEM capable of achieving a TWO Hour Fire Rating.

---------- TOP ----------

 

flame Spread

Flame Spread (FS) - Represents the surface burn characteristics of building materials.

The testing method is the 25-foot Steiner Tunnel test ASTM-E-84.

The material to be tested is used as the roof of a furnace forming a tunnel. The size of the material used is 20 inches wide by 25 feet. A controlled flame source is placed 12" from one end of the tunnel and regulated to touch the sample 4'6" in. The time required for the flame to travel the distance remaining of 19'6" is compared to Red Oak which was arbitrarily given the value of 100 and cement asbestos board which is given the value of 0. The results listed are proportionate to those values.

Flame Spread Definitions:

  Flame Spread Definitions
 
Flame Spread
0-25
26-75
76-200
201-500
500+
 
Fire Class
A / UL-11
B / UL-2
C / UL-3
D
E

 

---------- TOP ----------

 

Fire Ratings

Fuel Contribution

This is a time temperature curve developed by plotting the temperature measured by a thermocouple located at the 24 foot point (vent end) in the furnace. The value for fuel contributed is derived by calculating the net area under the curve for the test material and comparing this area with the net area under the curve for unfinished select grade 3/4" red oak flooring.

Smoke Developed

The smoke developed during the test is determined by the output of a photoelectric circuit operating across the furnace outlet pipe. A curve is developed by plotting against time the values of the decrease in photoelectric cell output due to obscuration of the light source across the pipe caused by the smoke. The value for smoke developed is derived by calculating the net area under the curve for the test material and comparing this area with the net area under the curve for unfinished select grade 3/4" red oak flooring.

Component Material Fire Ratings

  Component Fire
Class		 Flame Spread Fuel Contribution Smoke Developed
 
Cement Asbestos
 Class A 0 0 0
 
Red Oak Wood
Class C
100 100 100
 
Hardboard
Class C
 120 105 85
 
Gypsum 5/8"
Class A
0 0 N/A
 
Steel
Class A
0 0 10
 
Aluminum
Class A
 0 0 10
 
Diamond Coat™ Vinyl
Class A
13 10 3
 
Honeycomb Core
Class A
15 N/A 155-195
 
Polystyrene Core
Class A
 15 20-80 25-80
 
Isocyanurate Core
Class A
20 N/A 140
 
Mineral Ceiling Tile
Class A
25 N/A N/A

 

---------- TOP ----------